Rhino Shelter EXT ROUND-12WX24LX8H - Manual (Page 7)

Assembly Instructions Extended Round Style 12 x 24 x 8
V2.2
Please Do NOT Return Assembly to Dealer or Store. For All questions or Shortages please call MDM Products directly
Customer Service 800-447-7079 or 203-877-7070
7
The rope slot should be located inside the unit, with the
frame members passing through the pre-cut slots in the
end panel/door. Replace the carriage bolts after putting
the end panels into position.
When putting on the doors, adjust the length to make
certain the doors do not drape onto the ground. If pulling
them up puts too much stress on the slit where it goes
over the wind brace, use a sharp knife to cut slit another
inch or two to relieve it. The PE fabric is rip-stop weave,
and can easily be cut to relieve stress at the frame
members.
Step 3. Tie off one end of the rope coming out of the
end panel to a turnbuckle (turn-buckle should be
loosened all the way) and attach the turnbuckle to the
hole in the foot of the end arch. Hold the end of the
unsecured rope and apply downward pressure with a
foot to remove excess slack.
Re-adjust gathered material evenly along inside edge of
door rope slot. This step is key to getting a good door fit.
Tie off the end off the rope to a second turnbuckle (fully
opened) attached to a hole in the foot of the end arch on
the opposite side. The end panel can then be tightened
further by adjusting each turnbuckle.
Note: Adjust the end door panel by turning the
turnbuckles or repeating step 3 on a regular
basis
MAIN COVER INSTALLATION
Step 1. To elongate the life of Main Cover, put a small
square of duct tape (field supplied) over each bolt head
on frame that comes in contact with cover. The tape
acts as a cushion to avoid rubbing damage to the cover
over years.