Rhino Shelter EXT ROUND-12WX24LX8H - Manual (Page 9)

Assembly Instructions Extended Round Style 12 x 24 x 8
V2.2
Please Do NOT Return Assembly to Dealer or Store. For All questions or Shortages please call MDM Products directly
Customer Service 800-447-7079 or 203-877-7070
9
DOOR HOLD UPS
All Rhino Shelter doors are manufactured with a pocket
on the bottom edge along the width axis. A ½” - 1”
plastic or metal tube can be inserted into the pocket and
trimmed to fit door width. Weight will reduce door
movement in wind. Four (4) bungee straps are provided
to retain the door in the up position. Roll the door from
the bottom and secure the door roll with a bungee
through the upper door grommet as shown.
MAINTENANCE AND CARE
Annually or more often, the unit should be completely
inspected internally and externally to make certain the
unit remains properly installed and secured. Particular
attention should be paid to:
Hardware – check all carriage bolts and hardware
connectors to be certain they are in place and tightened.
Anchors – during normal weather trends, the unit will
strain against the anchors under windy conditions.
Anchor hardware connection to frame members should
be maintained tight and depth of anchors should be
checked to be certain they remain deeply and firmly set.
Snow Accumulation – all snow accumulation on the main
cover should be removed as soon as practical. The
days following a snowfall when snow melts are when the
most damage can occur. Unit is not designed for any
amount of accumulated snow or ice. Tap the main cover
from the inside with a broom end to knock off any
accumulated snow.
Main Cover Lacing – the poly rope that secures the main
cover to the bottom rail of the frame assembly should be
checked, and adjusted as needed. The tension on the
main cover should be uniform from end to end and side
to side. Rope ends must be tied off onto the frame
members at the ends on each side.
Turnbuckle Adjustment – during normal wind conditions
and load, the doors and main cover adjustment points at
the turnbuckle should be checked and tightened as
necessary. The turnbuckles should be neither
completely extended nor taken up, so that turnbuckle
should be tight when in the mid range of overall
adjustment. If necessary, readjust rope tie off on
turnbuckle as needed to tighten or loosen as needed.
Cleaning – cover and doors can be cleaned with a
mixture of light detergent and water. A soft bristle brush
with the mixture can be used to loosen any hard dirt,
mold, or buildup on the cover. After cleansing, the cover
should be rinsed thoroughly to avoid any chemical
reaction from residual detergent. Allowing dirt and
debris to sit on cover over an extended time will damage
cover irreparably.
Severe Weather – in preparation for inclement weather,
completely secure the doors on both ends of your Rhino
Shelter garage. Allowing wind to enter either end lifts
the building and puts undue stress on the anchoring
system. This also shortens the life of the doors, zippers,
and main cover.
CUSTOMER SERVICE & ASSISTANCE
Please call MDM Products at 800-447-7079 or 203-877-
7070 for questions about the installation of the unit in
any way. Care and attention to a proper installation will
add many years of life and function to your Rhino Shelter
unit.
Please retain purchase documentation for your Rhino
Shelter unit. All warranty claims must include purchase
documentation for verification. All parts on your Rhino
Shelter unit are available for replacement as needed.
Protect your purchase by completing warranty
registration card and mail/fax as soon as practical after
installing your unit.