RIKON Power Tools 60-200 - Manual (Page 6)

Fig. 01
Fig. 02
6
Assembly
Installing Casters to Base Plate
Locate the four swivel casters, four 12MM hex nuts
and four 12MM hex cap nuts from hardware pack.
1. Insert the threaded stud from swivel caster through
one of the four holes in the corner of the base plate.
2. Place 12MM hex nut and 12MM hex cap nut onto
threaded stud of swivel caster and tighten (Fig. 01).
3. Repeat steps 1 and 2 for the remaining three
swivel caster assemblies.
Attaching Motor Base to Base Plate
Locate the motor base, four M8X16MM hex bolts and
four 8MM washers.
1. Lay the motor base onto the base plate. Align the
holes in the motor base with the holes in the base
plate.
2. Place a washer over a hex bolt and insert through
the motor base into the the threaded hole in the base
plate and tighten (Fig. 02).
3. Repeat steps 1 and 2 for the remaining three
hex bolts.
Mounting Fan Housing & Motor to Base
Locate the fan housing and motor, Four M8X20MM
hex bolts and four 8MM washers.
1. Place the fan housing & motor onto the motor base
. Align the holes in the fan housing and motor with the
holes in the motor base.
2. Install a hex bolt through the holes on the motor
base and motor from underside of motor base, place
a washer and a hex nut on the top to tighten the bolt.
(A-Fig. 03).
3. Repeat step 2 for the remaining three mounting
positions and tighten.
4. Install a washer over a hex bolt and insert through
the strut in the fan housing into the the threaded hole
in the base plate (B-Fig. 03). Repeat for second strut.
Fig. 03
A
B