RIKON Power Tools 60-200 - Manual (Page 7)

7
Fig. 06
Fig. 07
Fig. 05
Fig. 04
Installing the 5” Outlet and Rubber Gasket
Locate the 5” plastic outlet, rubber gasket, six
M6X20MM hex bolts and six 6MM washers.
1. Place the rubber gasket on the flange of the fan
housing (A--Fig. 04).
2. Align the holes of the mounting flange on the fan
housing for the holes of the 5” outlet (B--Fig. 04) .
3. Secure the assembly with the six M6X20MM hex
bolts and 6MM washers.
Installing the Collector Supports
Locate the three collector support bars, six M8X15MM
hex bolts and six 8MM washers.
1. Hold one collector support bar upright over the
holes located near the caster mounting location as
shown on the base .
2. Insert the hex bolts and washers through the
collector support bar into the threaded holes in the
base and tighten (Fig. 05).
3. Repeat for the remaining support bars.
Installing the Collector & Upper Bag Support
Locate the collector, upper bag support, four
M8X15MM hex bolts and four 8MM washers.
1. With assistance, hold the collector in position and
align the front mounting holes.
2. Insert the hex bolts and washers through the
collector support bar into the front threaded holes in
the collector and tighten (Fig. 06).
3. Bolt the left collector support bar to the collector
adding the upper bag support as shown (Fig. 07) .
Note: If you purchased the optional canister the upper bag
support does not need to be installed.
A
B