RIKON Power Tools 70-100 - Manual (Page 7)

7
Installing Spindle Lock
Locate the spindle lock assembly from the carton,
and install it onto the head with an
adjustable
wrench. (See Fig.02)
Warning: Disengage spindle lock before turning
the machine on.
Spindle lock
Attaching Spur Center On The
Headstock
Insert spur center, with a No. 2 Morse Taper shank,
into the headstock spindle.(See Fig.03)
Fig.03
Spur center
Headstock spindle
Knockout Bar
The knockout bar is used to remove the spur center
from the headstock spindle. Insert knockout bar
into hole at opposite side from spur center.
(See Fig.04)
Fig.04
Knockout bar
Attaching Live Center On the Tailstock
Insert the live center, with a No. 2 Morse Taper
shank into the tailstock spindle. (See Fig.05)
Live center
Tailstock spindle
Fig.06
To remove live center from the tailstock spindle,
loosen locking arm and rotate the hand wheel
counter clockwise to retract spindle into the body of
the tailstock. The live center will be pushed out of
the spindle.
(See Fig.06)
Knockout bar
Fig.02
Fig.05