RIKON Power Tools 80-805 - Manual (Page 10)

CARTON CONTENTS
UNPACKING AND CHECKING CONTENTS
This Bench Grinder will require a minimal
amount of assembly.
1. Remove parts from all of the cartons and
lay them on a clean work surface.
2. Remove any protective materials and
coatings from all of the parts and the bench
grinder. The protective coatings can be
removed by spraying WD-40 on them and
wiping it off with a soft cloth. This may need to
be redone several times before all of the
protective coatings are removed completely.
CAUTION: DO NOT use acetone, gasoline or
lacquer thinner to remove any protective
coatings.
3. Compare the items to Figure C; verify that
all items are accounted for before discarding
the shipping box.
If any parts are
missing, do not attempt to plug in the power
cord and turn “ON” the Bench Grinder. The
Bench Grinder can only be turned “ON” after
all the parts have been obtained and installed
correctly.
Page 9
The following items are provided in the
shipping box:
A. Grinder (not shown)
B. Eyeshields (2)
C. Eyeshield mounting brackets (2)
D. Eyeshield mounting rod, left
E. Eyeshield mounting rod, right
F.
G.
H.
FIG. C
Spark arrestors, (2)
Tool rest support, left
Tool rest support, right
I.
J.
K. Eyeshield mounting brackets (2)
L.
M.
N. Tool rest knobs (2)
O. Hex bolts (2)
P. Wheel dressing tool
Tool rest, left
Flat Washers M6 (4)
Pan head screws w/ washers M5 x 10 (2)
Tool rest, right