RIKON Power Tools 80-805 - Manual (Page 12)

5. Assemble the Tool Rests (E) to the
Supports (F) with the supplied flat washers
(G) and `Adjustment Knobs (H) as shown.
See Figure F.
6. Adjust each Tool Rest until its inside edge
(I) is 1/16” from the grinding wheel. Firmly
tighten the knobs holding the supports. See
Figure F.
SPARK ARRESTORS (Fig. G)
1. Assemble the Spark Arrestors (A) to the
front surface of the Wheel Covers (B) with the
pan head screws and washers (C) as shown.
See Figure G.
2. Adjust each Spark Arrestor until the lower
edge (D) is 1/16” from the grinding wheel.
Then firmly tighten the pan head screws. See
Figure G.
3. As the griding wheel reduces in size from
use, re-adjust the spark arrestors so that thier
lower edges maintain the safe 1/16” spacing
from the wheel.
ASSEMBLY INSTRUCTIONS
The Bench Grinder is provided with
adjustable left and right positioned two-piece
tool rests to lay your workpieces on.
1. DO NOT assemble the Bench Grinder until
you are sure the tool IS NOT plugged in.
2. DO NOT assemble the Bench Grinder until
you are sure the power switch is in the “OFF”
position.
3. DO NOT assemble the Bench Grinder until
you are sure the grinding wheels are firmly
tightened to the Bench Grinder.
TOOL RESTS (Figs. E and F)
The Bench Grinder is provided with two
different Tool Rests assemblies. The Left Side
Tool Rest is grooved to accept drill bits. The
Right Side Tool Rest is entirely flat.
1. Assemble the Tool Rest Supports (A) to the
inside surface of the Wheel Covers (B) with
the flat and lock washers (C) and knobs (D)
as shown. See Figure E.
2. Loosen the knob and remove it and the flat
washers from the pre-assembled carriage bolt
(F). See Figure E.
3. Mount the Tool Rest Support onto the
inside of the wheel cover.
4. The lower channel on the Tool Rest
Support fits over the small post (E) that
extends out from the wheel cover. See Figure
E. The upper channel on the Tool Rest
Support is used for positioning the threaded
carriage bolts (F) that the washers (C) and
knobs (D) screw onto.
FIG. E
FIG. F
FIG. G
Page 11
F
E
F
G
H
E
I
A
B
C
D