RIKON Power Tools 10-320 - Manual (Page 6)

6
Installing Upper Trunnion to Table
Tools Required:
13 mm Wrench
Turn the table over and remove the wing nut (C)
from the trunnion carriage bolt (A) making sure the
end of the bolt projects down through the casting.
(See Fig.04)
Guide the table and upper trunnion on to the
bandsaw lower trunnion (G) and ensure the bolt (A)
projecting from the upper trunnion is inserted
through it’s corresponding hole in the lower
trunnion. When in position, tighten the wing nut (C).
(See Fig.04)
Insert the M8 x 50 carriage bolt and square plastic
insert (A) through the slot on the upper trunnion
casting (B) and, temporarily, screw on the wing nut
(C) to prevent it from falling out. (See Fig.02)
Install the upper table trunnion casting (B) to the
underside of the bandsaw table (D) using the four
M8 x 16 hex head set screws (E) and washers,
ensuring that the angle tilt scale is closest to the
edge of the table. (See Fig.03)
While the table is in the upside down position, add
the table stop screw and nut (F) as shown. This will
be adjusted later. (See Figs.02& 03)
Installing the Table to the Saw
(Some assistance may be needed for this)
Fig. 01
Fig. 02
Fig. 03
Fig. 04
A
B
C
D
E F
E
B
D
F
G A
Mounting the Saw to the Base Cabinet
(Some assistance may be needed for this)
The bandsaw has four holes (A) in the base
(See Fig.01) to allow it to be bolted to the base
cabinet. Lift the saw onto the base cabinet using the
frame. Do not lift bandsaw using the table. Install the
four bolts, eight washers and four nuts as shown in
the Base Cabinet Assembly instructions on page 5.
A
Install the plastic table insert to the center of the table
with the angled bevel facing downwards.
Assembly