RIKON Power Tools 10-320 - Manual (Page 7)

7
Tools Required: Flat blade screwdriver
10mm wrench
Attach the crank handle (A) to the belt tension
crank arm with the M6 x 55 slotted head screw and
two M6 nuts. (See Fig.06)
Assembling the Optional Rip Fence
Install the rear fence rail to the table with two M6-
1.0 x 20 hex bolts and two flat M6 washers.
Install the front fence rail to the table with four
thumbscrews and four flat M8 washers.
Make sure the end cap is locked into the rear fence
rail. Then set the fence on the front rail.
(See Fig.07)
Rip Fence Adjustment
The optional rip fence has three adjustments to
ensure proper performance. (See Fig.08)
Adjusting Fence 90 Degrees to Table: Loosen
slightly the two hex head screws which hold the
fence rail to the fence body. Raise or lower the four
micro-adjusting screws, located on the fence body
accordingly.
Correcting for Blade Drift: Loosen the two hex
head screws which hold the fence rail to the fence
body. Pivot the fence rail toward or away from the
blade to compensate for drift.
To Adjust the Rip Fence Guide Scale: Slide the
rip fence against the blade along the rail and
loosen the indicator screw . Then move the scale
sideways and align the zero on the scale with the
line on the magnifying window. Retighten the
indicator screw when the adjustment is correct.
Fig. 06
Fig. 07
Fig. 08
A
Installing the Belt Tension Crank Handle
Installing the 2-1/2" Dust Port
Assemble the 2-1/2" dust port to the bandsaw
frame with a hex socket head cap screw and
washer. Place the 2-1/2" dust port on to the side of
the bandsaw frame.
Locate two hex socket head cap screws and two
washers from the bag of loose parts. Mount the
dust port to the bandsaw frame and install a hex
socket head cap screw with washer in each hole,
then tighten with the M6 hex “L” wrench.
(See Fig.05)
Fig. 05