SHARKOON 2-Bay RAID Box - Manual (Page 6)

2-BAY RAID BOX
In a RAID 1 the data can be restored by rebuilding the
array (see 7.).
Data from an existing RAID 0, Standard or Combined
mode are lost. Change the defective HDD.
7. Rebuild
Note:
1. The new HDD must provide at least the same
capacity as the replaced one.
2. Do not change the RAID mode prior to the
rebuilding.
3. Do not change the HDD order before commencing
the rebuild process.
4. The rebuild procedure may take very long for
bigger HDDs (> 1 TB), but the RAID Box may be
used meanwhile.
1. Switch off the device.
2. Change the defective HDD.
3. Power on the device, the rebuild procedure
will start automatically even when the device
is disconnected from your PC. During this
procedure the status LEDs will be flashing. As
soon as the LEDs for HDDs lights up blue, the
procedure is completed and the device may be
accessed.