Tennsco Q-Line Shelving Open User Manual

Page 5

Advertising
background image

15.

OPTIONAL Label Holder: Place the label

holder (Ref. No. 7) on the front edge of the shelf

and secure with three P-38F plastic tabs.

16.

OPTIONAL Front Base Strip: Bolt front base

strip (Ref. No. 8) to the outside of the bottom

shelf with the three self-tapping screws provided.

Make sure that the ends of the front base strip

are behind the front flanges of the uprights.

13.

Position the remaining shelf clips according to

your desired shelf heights, and place the

shelves over the clips. Keep in mind, while

placing the clips, that the hole pattern of two

round holes and then one square hole,

repeated every 3", can greatly help in aligning

the clips evenly.

PLEASE NOTE: Some shelves, depending

upon placement, could possibly require

temporarily removal of one end of a sway

brace in order to insert the shelf.

14.

Tighten up all bolts and nuts on the rear and

side sway braces. There are fifteen bolts and

nuts to tighten, five for each pair of sway

braces.

Advertising