U.S. Sunlight 2014ST Cold Weather Lens Kit - Manual (Page 2)

Step 3
Stand the Diffuser on its side and carefully remove one side as shown in (fig. 10) and keep the unit upright in this position to install
the extra lenses. Peel off the protective film on both sided of each lens. (fig. 11) Then position the two lenses in the slots as indicated in
(fig. 12).
fig. 10 fig. 11 fig. 12
Step 4
With the unit upright, carefully lower the other half of the Diffuser Assembly making sure to align all 5 lenses in the slots on both sides.
(fig. 13)
Press firmly to fully seat each latch back into their original positions. The Diffuser must close completely to be reinstalled in the housing
properly.
(fig. 14 & 15)
fig. 13 fig. 14 fig. 15
fig. 16 fig. 17
Step 5
With the unit reassembled, clean off any dust or fingerprints and reinstall into the Housing Assembly as shown in
(fig. 16) Then replace the Trim Ring. (fig. 17) Your Cold Climate Lens Kit is now installed.
© Copyright 2011 US Sunlight Corp, Inc. 2014STLens C01 ver 1
Fit the lenses in
the two extra slots