Walker Magnetics TURBOMILL 40B - Manual (Page 11)

O.S. WALKER Co. Inc., Turbomill Electroperm Chucks
DD15508M.doc Rev. ~, September 17, 2002
3-2
3.1.1 Connecting the Chuck
The DC output to the chuck must include a ground wire that is connected to the safety
ground lug on the chuck and to the chassis of the chuck control. It is recommended that
the conduit for the DC output not be routed near high voltage AC wires. Many chucks
are installed on machines with moving tables. Choose a means of wiring the chuck that
allows adequate freedom of movement over the full range of table travel.