Walker Magnetics TURBOMILL 40B - Manual (Page 8)

O.S. WALKER Co. Inc., Turbomill Electroperm Chucks
DD15508M.doc Rev. ~, September 17, 2002
2-3
2.2.2 Additional Warnings
2.3 Designated Person
*Walker replacement parts may be installed by a **Designated Person.
** Designated Person - A person selected or assigned by the employer as being competent
to replace specific replacement parts listed in this manual and is able to verify the proper
functioning of the specific replacement parts and the entire product after the completion of the
installation.
•
Never operate damaged or
malfunctioning chuck.
•
Never remove or damage Operating
and Warning labels.
•
Persons using pacemakers or any
other medical devices should not use
this magnet until they have consulted
with their physician.
•
The electrically conductive body of
this chuck must be connected to a
proper electrical ground.
•
Disassembly or repair of this chuck control can result in
reduced holding power and/or cause an unsafe
condition. Therefore, any time the control is
disassembled or repaired it should be thoroughly
inspected and re-tested for proper electrical grounding
and power output.
•
Modification of any operating circuits and electrical
safety grounding can reduce the chuck control's
effectiveness and/or cause an unsafe condition.
•
Repair or modification of this chuck should only be
done by O.S. Walker*.