Walker Magnetics SMART-D SERIES - Manual (Page 6)

O.S. WALKER Co., Inc. SMART-D Control
SMART D MANUAL DD14511L Rev. L, March 30, 2011
2-1
2 SAFETY INSTRUCTIONS
2.1 General Safety Rules
Following these simple rules can help to avoid accidents:
• Never attempt to operate this control and your magnetic chuck until you read and
understand this operator's manual.
• Never disconnect a magnetic chuck from the control's DC power source while it is
energized! Electrical arcing will occur and may cause serious injury or death.
• Only qualified personnel shall make adjustments within the control while it is energized!
• Never operate the control and chuck until it has been verified that a proper electrical
ground for the control and Chuck has been established.
• Never perform any machining of work pieces on the magnetic chuck with the control
setting in the "Residual" mode.
• Never operate damaged or malfunctioning controls or magnetic chucks.
Remember, proper knowledge and techniques in the use of this equipment are the
responsibility of the operator. Be sure to read and understand the instructions and safety
warnings contained in this manual before using your chuck control and magnetic chuck.
If you do not understand everything in this manual contact O.S. Walker for assistance before
using the equipment.
CALL 1-800-W-MAGNET
IN THE USA
(In Canada call 905-643-3338; In Europe 31-4973-83835)