WEN 2307 101 Piece Rotary Tool Kit - Manual (Page 7)

7
LIST OF ACCESSORIES (100 pieces)
 Bit changing spanner wrench
 2 felt polishing wheels
 2 high speed cutters
 10 grinding stones
 54 sanding discs
 1 dressing stone
 20 cut-off wheels
 4 sander bands
 1 drum sander
 2 mandrels
  2 drill bits
  2 collets
GETTING TO KNOW THE ROTARY TOOL KIT
The rotary tool can be used for drilling, milling, grinding
and polishing. In addition, it can be used for engraving,
cutting and removing rust. It can be used on most metals,
glass, wood and ceramics.
Operating the ON/OFF Switch
1. The ON/OFF switch is located on the underside of
the handle. It has two setting “O” (OFF) and “I”
(On).
2. To switch on the tool, press the switch into “I “(ON)
position. There is no need to hold it down as it will
automatically lock in position.
3. To switch the tool off, simply press the switch back into the “O” (OFF) position.
4. Always ensure that the switch is in the OFF position before connecting the tool to the mains.
Always disconnect the tool from the mains when not in use.
Adjusting the Speed
1. The tool has a range of speed settings from 8,000 to 30,000 rpm. The speed can be adjusted using
the speed control wheel located on the top of the handle.
2. There are some signs, „1‟ „2‟ „3‟- „6‟and „MAX‟ marked on the wheel. To increase speed, turn
the wheel towards the „MAX‟ sign. To reduce speed, turn the wheel towards the „1‟ sign.
3. As a guide, use low speed for larger attachments and higher speed for small attachments.
4. Do not force the tool. Best performance is achieved by an even speed, not high pressure.
 High Speed Uses:
Higher speeds are better for carving, cutting, routing shaping. Hardwoods, metals and glass require
high speed operation and drilling should also be done at high speeds.
Warning: Do not use grinding wheels over 1” in diameter. The tool‟s high speed can cause
larger wheels to fly apart and could cause injury.