WEN 73002 500-Pound Capacity Service Cart - Manual (Page 3)

3
other parts will void the warranty.
7. Do not operate product if under the influence of alcohol or drugs. Read warning labels on
prescriptions to determine if your judgment or reflexes are impaired while taking drugs. If there
is any doubt, do not operate the product.
8. Use eye protection. Always wear ANSI approved impact safety goggles.
9. Do not exceed the product’s maximum load capacity of 500 lbs (250 lbs per shelf).
10. Only use on a flat surface capable of supporting the Service Cart and its maximum capacity load
of 500 lb. It is easy to lose control of the Service Cart if attempting to pull a load on a sloping or uneven
surface.
11. Do not allow children to play on, stand upon or climb on the Service cart. The Service Cart is not
for carrying people or animals.
12. Always check hardware and assembled parts after assembling. All connections should be tight and
hardware tightened.
13. Always distribute objects in the Service cart evenly. Uneven weight distribution could cause tipping.
Do not lean or climb on the Service Cart.
Warning: The warnings, cautions, and instructions discussed in this instruction manual cannot cover all
possible conditions and situations that may occur. It must be understood by the operator that
common sense and caution are factors which cannot be built into this product, but must be
supplied by the operator.
UNPACKING
When unpacking your Service Cart, please check the parts list and make sure all components are included.
The parts list can be found on Page 4.
ASSEMBLY
NOTE: Please refer to the Assembly Diagram for the following assembly instructions:
1. Select the shelf tray with the uninterrupted flat surface identified as (part 1) and place it upside down
on a flat work surface.
2. Locate the push handle, (part 3), turn it upside down with the cup holder towards the shelf tray,
using a rubber mallet, tap the push handle down into the grooves on the tray. Make sure the handle is
all the way on the shelf tray. Helpful Hint: To overcome the friction between two plastic surfaces,
rub a little petroleum jelly onto the grooved surface. The two parts should slide together with a few
gentle taps of the rubber mallet.