WEN 73002 500-Pound Capacity Service Cart User Manual
Page 4
4
3. Since all 4 legs, (parts 5 & 6) look alike, positioning of the legs can be confusing. Here is an easy
way to assemble the legs on the cart. Locate the two legs, (part 5) (note the positions of the bottom
flanges) and place one nearest the handle (part 3) and the other diagonally across the shelf tray
corner as shown on the assembly diagram. Using a rubber mallet, tap the legs onto the shelf tray
(part 1) until the tab with the 3 screw holes is in contact with the shelf tray. Repeat the process with
the other two legs (part 6) so all four legs are in solid contact with the shelf tray.
4. Insert and tighten the three screws per leg so that the legs are solid in the shelf tray (part 1). Hint:
Rub some soap on the screw before inserting and tightening it. The soap acts as a lubricant and
makes tightening the screw easier.
5. Now for the second tray (part 2). Turn the shelf tray upside down and place it onto the 4 legs (parts 5
& 6). The flanges on the 4 legs should fit into the depressions in shelf tray (part 2). Everything
should fit together if all 12 screws were secured through the 4 legs into the shelf tray (part 1). Gently
tap shelf tray (part 2) onto the 4 legs until the tabs and shelf tray depressions are in contact with each
other.
6. Insert the carriage bolts (part 10) up through the leg tabs and the shelf tray (part 2) and begin the
attachment of the casters. NOTE: The swivel casters (part 8) are located on the same side as the tray
(part 3). With the carriage bolt held in place, position the appropriate caster (part 8 or 9) over the
bolt, add the split washer (part 11) and hand tighten the nut (part 12). When all 4 nuts are in place,
use an adjustable wrench. Repeat process with the other 3 legs until all casters are secured in place.
7.
Turn the Service Cart upright. Make certain all hardware is tight. Make certain the casters roll
properly and enjoy using the cart.
PARTS LIST
Part
Description
Qty
Part
Description
Qty
1
Tray
1
9
Fixed Casters
2
2
Second Tray
1
10
Carriage Bolts
16
3
Handle
1
11
Washers
16
4
Pole on Handle
1
12
Nuts
16
5
Legs
2
6
Legs
2
7
Screw
12
8
Swivel Casters
2