ADT Security Services K5309V2 - Manual (Page 12)

– 12 –
(QWU\([LW'HOD\V
(QWU\'HOD\
Entry Delays give you time to disarm the system when you re-enter through the
designated entrance door. You must disarm the system (simply enter your security
code) before the entry delay period ends, or an alarm will occur. The touchpad beeps
during the entry delay period, reminding you to disarm the system. There are two
entry delays (if programmed). The first is for your primary entrance and the second
can be used for a secondary entrance, where a longer delay is required to walk to the
touchpad to disarm the system.
You can also arm the system with no entry delay at all by using the INSTANT
arming mode. This mode provides greater security while on the premises or while
away for extended periods of time.
See your installer for your delay times.
Partition 1 ___________________________________________________________
Exit Delay: seconds Entry Delay 1: seconds
Entry Delay 2: seconds
NOTE: Entry/Exit times set for partition 1 also apply to the common zone.
Partition 2 ___________________________________________________________
Exit Delay: seconds Entry Delay 1: seconds
Entry Delay 2: seconds
([LW'HOD\
Exit delay gives you time to leave through the designated exit door without setting
off an alarm. Exit delay begins immediately after arming your system in any arming
mode and Custom Display touchpads display the message “You May Exit Now.”
When
“You may exit now” disappears, the system is fully armed. If programmed, a slow beeping
will sound during the exit delay period, until the last 10 seconds, which then changes
to fast beeping (alerting you to the end of exit delay). If you cannot leave by this time,
you should stop, disarm the system, and start over to avoid a false alarm.
Exit Delay Restart (if programmed): If you wish to open the entry/exit door to let
someone in after arming STAY, you can re-start the exit delay at any time – simply
press the [✱] key, then let that person in. The system automatically re-arms when
exit delay expires, which avoids having to disarm the system and then re-arm it
again. In addition, when the system is armed AWAY, reopening and closing the
entry/exit door before exit delay time expires (e.g., reentering to get a forgotten item)
will reset the exit delay time.