Additel Land User Manual - Manual (Page 4)

4
Chapter 1 Introduction
This manual will introduce you to how to install, and use the Additel/Land. All screens have a uniform look with similar speed buttons and menus,
making it easy for you to adapt to the system quickly. Each subsequent chapter individually addresses one of the program’s screens or major functions.
In each of these chapters you will find a full description and explanation of the screens features, as well as detailed, hands-on operating instructions.
Chapter 2 Installation
2.1 System Requirements
To use the Additel/Land recommended that you have the following hardware and software:
 A Pentium class 667 MHz or higher computer with a minimum of 256 MB of RAM (512 MB or more recommended)
 Graphics monitor and card: (VGA color or better recommended)
 Windows XP or later operating system versions
 A hard disk with at least 500 MB of free space
 Microsoft Office 2003 or later versions
For calibrator communication:
 RS232 serial asynchronous communication port
 ADT672, ADT761 , ADT223A Series Calibrators (the version of calibrators is DPC2.10 or higher )
 Suitable communications cable (supplied)
2.2 Procedures
Insert the Additel/Land CD into your computer’s CD-ROM drive. If the program does not autostart, Run “setup.exe”. Follow the prompts on your screen
to complete installation.