AW Gear Meters HUB-40EX - Manual (Page 4)

HUB-40Ex Sensor
User Manual
AW Gear Meters 8809 Industrial Drive, Franksville, WI 53126  web: www.awgearmeters.com
 Tel: 262-884-9800  Fax: 262-884-9810  Email: [email protected]
HUB-40Ex User Manual rev1.2.docxError! Unknown document property name., 1/18/2012 PAGE: 4 of 4
Installation:

Ensure that the sensor cavity of the flow meter is free of debris prior to installation.

Mount the HUB-40Ex into the sensor cavity and fasten threads. NOTE: REFER TO SECTION TITLED Special
installation instruction for use in Hazardous Area environments FOR PROPER INSTALLATION
REQUIREMENTS!

Slightly loosen Swivel Union nut and adjust the junction box in the desired orientation.

Tighten the Swivel Union nut while maintaining the orientation of the junction box. To properly seal surfaces from
external environment, apply 65 ft-lbs (+/- 4 ft-lbs) of torque. It is recommended to use anti-seize grease on threads to
avoid galling.

Remove conduit plug from the junction box to allow wire access, and remove the junction box lid to allow access to
terminal block connections.

Connect the wires to the appropriate terminals shown in the wiring guide.

Reapply the junction box lid until fully engaged and fasten setscrew.

Seal off conduit connection. NOTE: REFER TO SECTION TITLED Special installation instruction for use in
Hazardous Area environments FOR PROPER INSTALLATION REQUIREMENTS!
Wiring Guide:
Part Number Guide: