COSA Xentaur Xentaur LPDT - Manual (Page 24)

Section 3: Instrument
page 17
3.4 Operating the Instrument
3.4.1 Starting up
The instrument is ready for use as soon as the power cable is
installed. When power is applied the instrument will initial-
ize its program and for a moment display
;(1, then it will
enter the Operating State. If the MODE button is held
pressed while the instrument is performing its power-up ini-
tialization, it will enter the Set-Up State, which allows the
user to select operating variables of the instrument.
To accommodate a variety of installation possibilities, the
LPDT front panel may be rotated (360°) by gently pressing
down on the spring loaded face plate and turning it to the
desired position.
3.4.2 Display Conventions
1. To display characters with the 7 segment numeric dis-
play, the following pseudo-alphanumerics are used:
Numbers:
0 12 3 4 5 6 7 8 9
        
Letters:
ABCDEF GH IJ LNOP QRS TUXYZ
$ % & ' ( ) * + , - / 1 2 3 4 5 6 7 8 ; < =
Symbols:
?
- .
"  
2. The instrument will indicate whether a particular mode
lets you change a parameter by showing the word
“SET” in the upper left corner of the display. Be careful