Figure 7 ac terminals – Detcon SW-AV1-N4 User Manual
Page 9
SW-AV1-N4
SW-AV1-N4 I.M.
Rev. 0.0
Page 5 of 8
3. Place the battery in the bracket, and re-install the bracket in the unit, securing it with the 6-32 screws
removed earlier. Locate the small plug from the battery bracket, and plug it into the receptacle from
the transceiver.
Figure 8 Battery Connections
4. Terminal Blocks are provided for AC connection to the Unit.
The power supply is rated for
110~220VAC, 50~60Hz operation. Connect the incoming AC power to the terminals labeled ‘VAC
(L1)’, ‘NEU (L2)’, and ‘GROUND’.
V
A
C
(L
1
)
N
E
U
(L
2
)
G
R
O
U
N
D
Figure 9 AC Terminals
5. The unit RXT-320 should be set to the correct RF Channel, and Modbus™ address for the alarm
station to communicate with the network. The RL4 Module should also have the correct Modbus™
address set for the RL4 to communicate properly with the controller.
6. When all connections have been made, and the RXT-320 Modbus™ and RF Channel have been
properly set, apply power to the unit.