Connecting the scanner to the macintosh computer – AGFA E20 User Manual
Page 24
Chapter 3: Installing the Scanner for Macintosh
24
Connecting the Scanner to the Macintosh
Computer
Caution
: For your safety, use the adapter that comes with this product. Do not use any substitute.
Misuse of the power adapter can cause serious damage to the product and a safety hazard while
using it.
Note: Check if the AC Adapter complies with your local power supply.
Note: Make sure the scanner is unlocked (see
before connecting it to
the electric outlet.
1
Connect the plug of the AC adapter to your scanner.
2
Connect one end of your USB cable to the USB port on your scanner. Make sure you connect
the correct plug as shown in the figure above.
3
Plug the adapter in the wall outlet.
4
Connect the other end of your USB cable to a USB port on your computer. Make sure you
connect it to the correct port as shown in the figure below. A USB port is labeled with the USB
icon .