Edwards Signaling Integrity Synchronized Temporal Horn-Strobe - Manual (Page 2)

2 / 6 P/N 3100376 • REV 6.0 • ISS 06MAY11
To install the temporal horn-strobe:
1. Select and install a suitable electrical box. See “Mounting
the electrical box” on page 3 for details.
Note: Outdoor installations require a weatherproof
backbox.
2. Set the horn volume and tone. See “Selecting the volume
and tone” on page 3 for details.
3. Bring the signal circuit field wiring into the electrical box.
4. Position the mounting plate on the electrical box with the
hook flange up and facing outward as shown in Figure 1.
Fasten the plate using screws provided with the electrical
box.
5. Connect the signal circuit field wiring. For the unit to
function properly, observe polarity.
To connect the horn and strobe on the same circuit, see
Figure 2. To connect the horn and strobe on different
circuits, see Figure 3.
For additional wiring details, see the installation
instructions for the signaling modules or circuits used in
the fire alarm control panel.
6. After completing the connections, attach the unit to the
mounting plate, as noted below.
a. The grille has tabs (at the top of the inner face) that
engage with the hook flange on the mounting plate.
Angle the bottom of the grille out slightly, and slide the
unit into place so that the tabs engage the flange.
b. Seat the grille by pressing the bottom in.
c. Fasten the bottom of the grille to the mounting plate
by tightening the captive locking screw.
7. Apply power and activate the unit to verify that it is
operating properly.
Figure 1: Mounting diagram
5-59/64 in.
(150 mm)
3-13/32 in.
(87 mm)
5-59/64 in.
(150 mm)
5/8 in.
(16 mm)
2-1/8 in.
(54 mm)
5-5/8 in.
(143 mm)
5-5/8 in.
(143 mm)
3-5/16 in
(84 mm)
(1)
(3)
(4)
(5)
(2)
(6)
(7)
(8)
(9)
.
5-1/2 in.
(140 mm)
5-1/2 in.
(140 mm)
F
I
R
E
(1) Gasket
(2) Weatherproof
box
(3) Standard box
(4) Knockouts for 1/2 in. (13 mm) or 3/4 in. (19 mm) conduit top,
bottom, back
(5) Surface mount box
(6) Mounting plate (supplied)
(7) #8-32
screw
(8) Captive locking screw
(9) Hook
flange