Edwards Signaling B-KBP-5060-N5 - Manual

P-047550-1611 ISSUE 1
© 1996
CHESHIRE, CT 203-699-3000 FAX. 203-699-3075
™
Installation Instructions for Catalog Number
B-KBP-5060-N5 Remote Call Bell
Figure 2. Wiring Diagram
The telephone company may make changes in its communica-
tion facilities, equipment, operations, or procedures when such
action is required. If these changes render the devices incom-
patible with the telephone company facilities, the telephone com-
pany will provide enough written notice so that necessary changes
can be made in order to maintain uninterrupted service.
ELECTRICAL SPECIFICATIONS
DESCRIPTION
The Edwards Catalog Number B-KBP-5060-N5 Remote Call
Bell is a completely self-contained 120V 60 Hz remote tele-
phone ringing unit that operates on ringing or key voltages. The
Remote Call Bell can be activated by either AC or DC voltage
and provides 100 dB at 10 feet.
The Remote Call Bell is weather and dust resistant and can be
used either indoors or outdoors.
• These devices are intended for connection to single line
telephone or key systems only. They are not intended for
use on "party line" or on coin telephone lines.
• When installed in accordance with these instructions, the
devices can be readily disconnected without affecting
equipment remaining on the telephone network.
• Registered with the Federal Communications Commission
in compliance with Part 68 of FCC Rules and Regulations.
IMPORTANT TELEPHONE INFORMATION
The following information may be required by the telephone
company: Telephone Number, FCC Registration Number:
3Z9USA-21250-RG-N, Ringer Equivalence Number (REN):
1.5B at greater than 50 Volts and 3.4B at less than 50 Volts.
The REN allows the installer to determine the number of de-
vices that can be added to the telephone line and still have all
the devices ring when the number is called. In most but not all
areas, the sum of all RENs for all devices connected to your line
should not exceed five. To be sure of the number of devices you
can connect to your telephone line, contact your local telephone
company.
If these devices damage the telephone network, the telephone
company will notify the owner that it may temporarily discon-
nect service if they consider such action necessary. If the owner
considers the disconnection unwarranted, they have the right to
bring a complaint to the FCC.
Figure 1. Dimensions
Input Max. Switching Max Amps
Cat. No. Desc Voltage Voltage Switch
B-KBP-5060-N5 Complete 50-250 AC 240 AC 5.0
Phone 16-70 Hz
Call Bell 10-150 DC 48 DC 1.5