Edwards Signaling B-KBP-5060-N5 - Manual (Page 2)

INSTALLATION
1. Mount backbox to wall or other surface with screws and fiber
washers provided. (Fiber washers must be located between
screw head and backbox to ensure weather-tight seal.)
2. Attach conduit and feed telephone cable through conduit, or
weatherproof cord grip in the 3/4" (19.05 mm) tapped hole at
top of box.
3. Connect telephone leads to terminal screws on PC board
(Figure 2).
4. Attach conduit and feed AC cord through conduit, or
weatherproof cord grip in the 3/4" (19.05 mm) tapped hole at
bottom of box. Connect AC supply to Input terminal screws
on the PC board (Figure 2).
NOTE: If bell rings continuously, reverse the telephone leads at
PC board.
5. Match tongue on top of weatherproof backbox to slot on top
of bell housing to attach bell. Ensure rubber gasket is seated
properly on back of bell housing and tighten bottom screw on
bell housing.
P-047550-1611 ISSUE 1