HT instruments М75 - Manual (Page 12)

M72 - M73 - M74 - M75
EN - 10
8. Example of display of DC voltage. The
minimum reading limit of DC voltage is
1.2V. Lower input values are displayed
as 0.0V
DC voltage value
9. Press MODE/PEAK for less than 1 second to pass to frequency measurement (only
during AC measurement)
10. Press MODE/PEAK for more than 1 second to detect the voltage peak value (see §
4.6.3)
11. Press FUNC/HOLD for less than 1 second to block the detected values on the display
(see § 4.6.1)
12. Press FUNC/HOLD for more than 1 second to detect maximum, minimum and
average voltage values (see § 4.6.2)
Frequency measurement
1. In order to detect minimum, average, maximum and peak values of frequency it's
necessary to pass to this measuring parameter
2. During AC measurements it’s possible to pass to frequency measurement by pressing
MODE/PEAK for less than 1 second
3. Example of display of frequency value.
The minimum reading limit of frequency
is 30.0Hz. Lower input values are
displayed as <30.0Hz
Frequency value
4. To resume voltage measurement press MODE/PEAK for less than 1 second
5. To detect the frequency peak value press MODE/PEAK for more than 1 second (see §
4.6.3)
6. To block the detected frequency value on the display press FUNC/HOLD for less than
1 second (see § 4.6.1)
7. To detect maximum, minimum and average frequency values press FUNC/HOLD for
more than 1 second (see § 4.6.2)