Allied Telesis AT-2916SX - Manual (Page 29)

Advanced Control Suite User’s Guide
29
– Not Present (Default). Uses the factory-assigned node address on
the adapter.
The appropriate assigned ranges and exceptions for the locally
administered address include the following:
* The range is 0000 0000 0001 to FFFF FFFF FFFD.
* Do not use a multicast address (least significant bit of the high
byte = 1).
* Do not use all 0s or all F's.
ˆ Speed & Duplex. The Speed & Duplex property sets the connection
speed and mode to that of the network. Note that Full-Duplex mode
allows the adapter to transmit and receive network data
simultaneously.
Note
This parameter is available only for copper devices and is not
displayed for the AT-29xxSX Series adapters.
– 10 Mb Full. Sets the speed at 10 Mbit/s and the mode to Full-
Duplex.
– 10 Mb Half. Sets the speed at 10 Mbit/s and the mode to Half-
Duplex.
10 Mb Half and 100 Mb Half settings force the network adapter to
connect to the network in Half-Duplex mode. The network adapter
may not function if the network is not configured to operate at the
same mode.
– 100 Mb Full. Sets the speed at 100 Mbit/s and the mode to Full-
Duplex.
– 100 Mb Half. Sets the speed at 100 Mbit/s and the mode to Half-
Duplex.
10 Mb Full and 100 Mb Full settings force the network adapter to
connect to the network in Full-Duplex mode. The network adapter
may not function if the network is not configured to operate at the
same mode.
– Auto (default). Sets the speed and mode for optimum network
connection (recommended). This setting allows the network
adapter to dynamically detect the line speed of the network.
Whenever the network capability changes, the network adapter
automatically adjusts to the new line speed and duplex mode. A
speed of 1 Gbit/s is enabled by selecting Auto, when that speed is
supported.