Acer 510 - Manual (Page 42)

34 System Utilities
Startup Configuration
The Startup Configuration screen contains parameters that are related to
computer startup.
The following table describes the parameters in this screen. Settings in
boldface are the default and suggested parameter settings.
Parameter Description
Boot Display Sets the display on boot-up.
When set to Auto, the computer automatically determines the
display device. If an external display device (e.g., monitor) is
connected, it becomes the boot display; otherwise, the
computer LCD is the boot display. When set to Both, the
computer outputs to both the computer LCD and an external
display device if one is connected.
Options: Auto or Both
USB Function
Support Enables or disables the USB (Universal Serial Bus) function.
Options: Disabled or Enabled
Hotkey Beep When enabled, the computer gives off a beep when a hotkey
(key combination is pressed). See "The Euro Symbol" for
details on hotkeys.
Options: Enabled or Disabled
ACPI OS Fast
Boot When set to enabled, the Quiet Boot and the PnP OS is
disabled or inactive.
Options: Enabled or Disabled
Quiet Boot When set to enabled, the system will boot to the OS as fast
as possible and proceed quickly through POST. This mode
will not show any boot progression messages, nor will it
perform any memory and diagnostic test.
Options: Enabled or Disabled