KEPCO BOP 1KW-MG Operator Manual, Firmware Ver.2.01 to 2.37 - Manual (Page 21)

BOP HIPWR 022108
1-3
OUTPUT CHARACTERISTICS (Continued)
Readback
rate/array measurement rate
5 ms (default) range (voltage or current): 500 µ sec to 500ms
range (voltage + current): 1msec to 250ms
measurement array 64 samples Voltage
128 samples Current
Voltage stabilization in
voltage mode
source effect
0.05% of rating min-max input voltage
load effect 0.1% of rating 0-100% load current
time effect (drift) 0.02 of rating 0.5 through 8 hours
temperature effect 0.02%/deg C of rating 0 to 50 deg C
ripple and noise 2% E0max p-p Includes switching noise
Current stabilization in
current mode
source effect
0.05% of rating min-max input voltage
load effect 0.2% of rating 0-100% load voltage
time effect (drift) 0.02% of rating 0.5 through 8 hours
temperature effect 0.02%/deg C of rating 0 to 50 deg C
ripple and noise 2% I0max p-p Includes switching noise
Error sensing 0.25V per wire Above rated output
Transient recovery in volt-
age mode
maximum excursion
5% of nominal output nominal voltage, 50% load step
Recovery time 200 µ sec Return within 0.1% of set voltage
Isolation voltage 300V Output to ground
Series operation
Master/slave Maximum of identical 3 units,
up to 300V max.
Parallel operation Master/slave Maximum of 5 identical units
Series-parallel Operation
2 series x 2 parallel
3 series x 2 parallel Master/slave for both series and parallel
branches of identical units
Output Protection limiting
voltage and current limited in four quadrants, adjustable between ±Internal minimum
EO
MIN
or IO
MIN
(box) (see Figure 1-2) and ±1.01 EO
NOM
or IO
NOM
.
Output Stage Protection
Output overvoltage/overcurrent
Heatsink overtemperature,
switchers overcurrent
Triggers latched shutdown protection of the
output module and PFC stage. Recover by
cycling power off, then on or by pressing
RESET at the front panel.
Input Stage Protection (PFC)
Internal overvoltage, undervoltage,
overcurrent, heat sink
overtemperature, fan inoperative
Input circuit breaker overcurrent Trips circuit breaker to shut off unit
Small signal
Bandwidth
voltage channel 2 KHz minimum Into nominal resistive load 10% of rating
current channel 800 Hz minimum Into short circuit, 10% of rating
Rise/Fall time voltage channel 250/200
µ
Sec
Into nominal resistive load, measured from 10
to 90%, from 0 to ±100% of rating
current channel 0.7/1.2 mSec
Into short circuit, measured from 10 to 90%,
from 0 to ±100% of rating
TABLE 1-2. BOP GENERAL SPECIFICATIONS (Continued)
SPECIFICATION RATING/DESCRIPTION CONDITION