Ayre Acoustics AX-7 - Manual (Page 10)

low setting. After that, the current volume setting is
retained in memory, and will remain constant when
changing inputs or when the unit is placed in
“Standby”.
Input Source Selection
The source component may also
be selected with the remote
control.
The input selector buttons are located at the right
side of the unit. Icons that match the connector
labels on the rear panel (Star, Planet, Comet, Moon)
are used to denote the inputs.
When the unit is first connected to an AC power
source, the “Star” input is selected by default. After
that, the current input selection is retained in
memory, even when the unit is placed in “Standby”.
The input selector utilizes sophisticated FET
switches. Both the signal and ground connections to
each source component are switched, so that any
un-selected components are completely disconnected
from the system. This avoids any problems with
undesired ground loops.
8
A y r e