Asus K8V-X SE - Manual (Page 51)

ASUS K8V-X SE motherboard 2-15
HT DATA Width (Upstream) [16 BIT]
Allows selection of HyperTransport upstream data width.
Configuration options: [16 BIT] [8 BIT]
HT DATA Width (Downstream) [16 BIT]
Allows selection of HyperTransport downstream data width.
Configuration options: [16 BIT] [8 BIT]
Memory Configuration
Memory Configuration
The Memory configuration menu item allows you to change the memory settings.
Select an item then press <Enter> to display the sub-menu.
Memory Configuration
Memory Configuration
Memory Configuration
Memclock Mode [Auto]
Software Memory Hole [Enabled]
Bank Interleaving [Auto]
Burst Length [4 Beats]
MCT Timing Mode [Auto]
TWCL [Auto]
TWR [Auto]
AsyncLat [Auto]
Read Preamble Setting [Auto]
2T Command [Auto]
Memclock Mode [ Auto]
Allows you to set the memory clock mode. Set by the code using [Auto] or
select [Manual] to set using one of the standard values.
Configuration options: [Auto] [Limit]
Software Memory Hole [Enabled]
Enables or disables the software memory remapping around the memory hole.
Configuration options: [Auto] [Disabled]
Bank Interleaving [ Auto]
Sets whether to allow memory accesses to be spread out over BANKS on the
same node or across nodes, decreasing access contention.
Configuration options: [Auto] [Disabled]
Burst Length [4 Beats]
Sets the Burst Length. Configuration options: [8 Beats] [4 Beats] [2 Beats]
MEMCLK can be set
by the code using
AUTO, or if you use
LIMIT, you can set
one of the standard
values.