Asus K8V-X SE - Manual (Page 56)

2-20 Chapter 2: BIOS Setup
2.4.3 Onboard Devices Configuration
Onboard AC’97 Audio [Enabled]
OnChip SATA BOOTROM [Enabled]
OnBoard LAN [Enabled]
OnBoard LAN Boot ROM [Disabled]
Serial Port1 Address [3F8/IRQ4]
Parallel Port Address [378]
Parallel Port Mode [ECP]
ECP MOde DMA Channel [DMA3]
Parallel Port IRQ [IRQ7]
OnBoard AC’97 Audio [Enabled]
[Auto] allows the BIOS to detect whether you are using any audio device. If an
audio device is detected, the onboard audio controller is enabled; if no audio
device is detected, the controller is disabled.
Configuration options: [Disabled] [Enabled]
OnChip SATA Boot ROM [Enabled]
Allows you to enable or disable the onchip Serial ATA boot ROM.
Configuration options: [Disabled] [Enabled]
OnBoard LAN [Enabled]
Allows you to enable or disable the onboard LAN controller.
Configuration options: [Disabled] [Enabled]
OnBoard LAN Boot ROM [Disabled]
Allows you to enable or disable the onboard LAN boot ROM.
Configuration options: [Disabled] [Enabled]
Serial Port1 Address [3F8/IRQ4]
Allows you to select the Serial Port1 base address.
Configuration options: [Disabled] [3F8/IRQ4] [2F8/IRQ3] [3E8/IRQ4] [2E8/IRQ3]
Parallel Port Address [378]
Allows you to select the Parallel Port base addresses.
Configuration options: [Disabled] [378] [278] [3BC]
Parallel Port Mode [ECP]
Allows you to select the Parallel Port mode.
Configuration options: [Normal] [Bi-Directional] [EPP] [ECP]
EPP Version [1.9]
Appears only when the Parallel Port Mode is set to [EPP]. This item allows you
to to select the Parallel Port EPP version. Configuration options: [1.9] [1.7]