KROHNE CORIMASS E Series EN - Manual (Page 44)

44
Fct. No. Text Description and settings
3.9.0 TUBE PARAMS Submenu 3.9.0 Transducer calibration and
compensation parameters*
3.9.1 Fgw CF1 Drive frequency - water: from Calibration Certificate
3.9.2 Fcw CF2 Coriolis frequency - water: from Calibration
Certificate
3.9.3 Fgl CF3 Drive frequency - air: from Calibration Certificate
3.9.4 Fcl CF4 Coriolis frequency - air: from Calibration Certificate
3.9.5 GK CF5 Transducer mass flow calibration constant: from
Calibration Certificate
3.9.6 LIN CF6 Linearity adjustment: from Calibration Certificate
3.9.7 Tcl CF7 Mass flow temperature compensation: from
Calibration Certificate
3.9.8 Tc0 CF8 Mass flow temperature compensation at zero flow:
from Calibration Certificate
3.9.9 TcD CF9 Density temperature compensation: from Calibration
Certificate
3.9.10 D.REF.WATER Use
↑
key to select between two modes, then press
↵
to
select submenu and then
↑
for choice of parameters
* MEAS.VALUE
CALIB. NO
CALIB. YES
* SET VALUE
freq Hz
temp
°
C (
°
F)
density g/cm
3
3.9.11 D.REF.AIR Use
↑
key to select between two modes, then press
↵
to
select submenu and then
↑
for choice of parameters
* MEAS.VALUE
CALIB. NO
CALIB. YES
* SET VALUE
freq Hz
temp
°
C (
°
F)
density g/cm
3
* Many, but not necessarily all, compensation parameters are shown on instrument data
plate.
These menus, except 3.9.10 and 3.9.11, are protected by the Code 4 password; see
Fct. 3.8.8.