KROHNE OPTIMASS with MFC 05x EN - Manual (Page 56)

Installation and Operating Instructions OPTIMASS 55
4.3.1 How to enter programming mode
To start:
Display Comments
→ Press Fct. 1
OPERATION
or If this appears, see box: ”Function of the keys ” in 4.3.
CodE 1
--------- If this appears on the display, set the 9-keystroke Supervisor CodE
1 .
Factory setting:
→ → → ↵ ↵ ↵ ↑ ↑ ↑
1 st - 8 th place
(key)
CodE 1
∗∗∗∗∗∗∗∗-
Each keystroke acknowledged by " * " in display.
9 th place
(key)
Fct. 1
OPERATION
If this appears, see box: ”Function of the keys ” in 4.3.
XXXXX
CODE WRONG
A wrong Supervisor CodE 1 was keyed in. Press any key and set
the correct 9-keystroke Supervisor CodE 1.*
* If correct code is not known, note number given (XXXXX) and contact KROHNE for further instructions
regarding decoding.
4.3.2 How to terminate Programming mode
To terminate:
Display Comments
Press ↵ 1-5
times
Fct (1).0
OPERATION Press ↵ 1...5 times until the cursor is under the extreme left menu
column. (Fct. 1, 2, 3, 4 or 5).
↵ + 12.3
kg/min
or If no changes have been made to the system’s configuration return
directly to the measurement mode.
(ACCEPT YES) Changes have been detected. Press ↵ to accept these changes.
or
↑ (ACCEPT NO) Press ↵ to reject changes and return directly to measurement
mode.
or
↑ (GO BACK) Press ↵ to return to the menus, Fct. 1.(0) to make further changes
Return to measurement mode.