Precision Control Systems StripIR 4185 - Manual (Page 10)

Assembly
Remove the Model 4185 heater from its shipping container and associated packaging.
Check the entire unit for any potential damage due to shipping. In the unlikely event
damage has occurred, keep all shipping containers and materials and file a damage
claim with the shipping company that delivered the heater.
• Phillips
Screwdriver
• Pliers
• Wire
Stripper
NOTE:
The Reflectors and Lamp are shipped separately and must be installed prior to operation.
Refer to Figures 3-1 Reflector and Lamp Assembly operations.
1. Remove both Ceramic End Covers, item 1, from both End Reflector assemblies, item
4.
2. Remove End Reflector assemblies, item 4, from Heater Housing, item 2, on the end
opposite Power Cord, item 19.
3. Slide Reflectors, item 3 into Heater Housing, item 2.
4. Reassemble End Reflector, item 4.
CAUTION!
5. From the end of the assembly insert the Lamp, item 18, through the End Reflector
openings
6. Trim approximately 4“ off each Lamp Lead then strip.25” of insulation off each Lamp
Lead.
7. Insert Lamp Lead into Terminal Blocks, item 17, to make connections to power
wiring. Repeat at other end.
8. Reassemble End Covers, item 1.
3-1
Section 3
UNPACK AND
CHECK FOR
DAMAGE
REQUIRED TOOLS
REFLECTOR
AND LAMP
INSTALLATION
Wear soft, clean, oil-free flannel or plastic gloves when handling halogen, quartz
lamps. Oils and contaminants are readily transmitted to the quartz by unprotected
hands and can cause premature lamp failure.