Revo REJCPTZ-2 - Manual (Page 11)

【#】+【PRESET】: The camera moves to Preset #.
【SHIFT】+【PRESET】: No function
【#】+【SHIFT】+【PRESET】: Shortcut to create a preset at value #
(Cancel/OK is displayed)
【250】+【PRESET】: Factory setup menu(Dwell Time, Answer Delay)
【AUTO】Brings up Auto scan setup menu
【AUTO】: Auto scan setup menu is displayed
【#】+【AUTO】:Auto scan # is started
【SHIFT】+【AUTO】: No function
【#】+【SHIFT】+【AUTO】: Writes to Preset# without asking for confirmation
【CANCEL】Exit Keyboard menu or clear data
【CANCEL】: Exit keyboard menu or exit key test menu
【#】+【CANCEL】: No function
【SHIFT】+【CANCEL】: No function
【#】+【SHIFT】+【CANCEL】Clear Preset # (Preset clear cancel/OK is displayed)
【ENTER】Confirm key or used to change value in some submenu
【ENTER】: Enter into keyboard menu, key test menu; change protocol,
baud rate, sound when entering corresponding submenu
【#】+【ENTER】: Change camera ID to # (when using more than
one PTZ camera)
【SHIFT】+【ENTER】: No function
【#】+【SHIFT】+【ENTER】: No function
【ON】This key can be used for some shortcuts.
Some shortcuts that work with the REVO 22x PTZ camera are shown below.
Other cameras may have similar shortcuts.
Number Area:
Number keys: 1, 2, 3, 4, 5, 6, 7, 8, 9, 0
Delete key: CANCEL
Confirmation key: ENTER
Function Area:
P/T Key: PRESET, MENU, AUTO, TOUR, ON,ESC
Special Function: F1
Assistant Function Key: SHIFT
Joystick: To control Pan and Tilt (Up/Down, Left/Right). Twist for zoom in
and out. Hold the CTRL button to increase the Pan/Tilt speed.
LCD Screen: Displays data.
CTRL key is on the top of the Joystick.
Keyboard Back Panel：
NOTE: The port marked “COM” has no function. Do not connect anything to this
port.
WARNING: DO NOT CONNECT THE KEYBOARD’S “COM” PORT TO ANY
INTERNET PROTOCOL DEVICE OR COMPUTER NETWORK!
6 13