Revo REHB0309-1 Quick Installation Guide - Manual (Page 11)

REHB0309-1, Quick Installation Guide
11
3.6 Resetting to the factory default settings
To reset the Network Camera to the original factory settings, go to the Setup>System >Maintenance
web page (described in “3.5.6 System>Maintenance” of the User’s Manual) or use the Reset button on
the network camera, as described below:
Follow the instructions below to reset the Network Camera to the factory default settings using the
Reset button.
1. Switch off the Network Camera by disconnecting the power adapter.
2. Remove the rear cap of the camera.
3. Press and hold the Reset button with a straightened paperclip while reconnecting the power.
3. Keep the Reset button pressed during about 2 seconds.
4. Release the Reset button.
5. The network
camera resets to factory defaults and restarts after completing the factory
reset.
6. Close the rear cap of the camera.
CAUTION: When performing a Factory Reset, you will lose any settings you have saved.
3.7 More Information
For more information, please see the Network Camera User’s Manual, which is available on the CD
included in this package.