Revo REHB0309-1 Quick Installation Guide - Manual (Page 5)

REHB0309-1, Quick Installation Guide
C. Connect connection cable and network lines.
D. Fit the screw holes of the mount base into the plastic anchors.
E. Remove the conduit knockout punched for the cable entry.
F. Screw up the mount screws (M5x20).
G. Adjust the camera suitably using the pan & tilt function, and fasten the mount screws (M6x16)
to fix the camera.
2. Installation
2.1 Connection
• Connecting to the RJ-45
Connect a standard RJ-45 cable to the network port of the network camera. Generally a
cross-over cable is used to connect directly to a PC, while a standard cable is used to connect
to a hub or router.
 Micro SD memory slot on the Rear Board
Remove the rear cap of the camera to insert the SD memory card.
• Connecting the Power
Connect the power of DC12V for the network camera. Connect the positive(+) pole to the ‘+’
position and the negative(-) pole to the ‘-‘ position for the DC power.
5