Satechi Swift Bluetooth Portable Speaker System - Manual

Swift BT Speaker User Manual
INTRODUCTION
Thank you for purchasing the Swift BT Speaker. The speaker is a high quality wireless audio device that
provides users the freedom to share music and calls whenever you want.
OVERVIEW
The Speaker contains the following parts as show in the figure:
1. Multi-function button (MFB)
2. LED light
3. USB charging port
4. On/Off Button
5. Microphone
OPERATION
1. Turn on: When the speaker is in the OFF state, switch the On/Off Button to “ON” and the LED will flash
with a blue light along with an audible tone.
2. Turn off: When the speaker is in the ON
state, switch the On/Off Button to “OFF” and the LED will flash
with a red light along with an audible tone.
3. Pairing: When the speaker is in the ON state, press the MFB button for about 6 seconds until the LED
flashes blue and red. The speaker is now in the pairing mode. Go to yo ur device’s Bluetooth settings and
select the speaker and enter “0000” for the passcode.
- Answer a call: press the MFB once
- Reject an incoming call: press and hold the MFB for 2 seconds
- End a call: Press the MFB once
- Redial last number: Press the MFB for about 3 seconds when on standby mode
- Voice dialing: It is possible to make a call directly from the headset using voice recognition. To use this
voice dialing function, your mobile phone must support this option: enable voice recognition on your
phone; when no call is in progress, press and hold the MFB.