SUOMY Rumble - Manual (Page 21)

FRONT PART : ADJUSTING see figure 3A
Loosen without removing the three screws on the right, left and
central part.
Adjust the position of the front part rotating it upwards or downwards
until the desired position is obtained. After finding the position, tighten
the three screws and re-check the position of the front part.
For all these operation, use the proper tool to tighten these
screws.
FRONT PART : REPLACING see figure 3B
Loosen and remove the three screws placed on the t right, left and
central part.
Position the new front part by making the holes match with the three
threaded fittings on the shell. Insert the screws in the specific
housings without tightening completely.
Adjust the position of the front part and lock it into position as
indicated in above paragraph.
For all these operation, use the proper tool to tighten these
screws.
USER’S INSTRUCTIONS ENG
figure 3A
figure 3B
19