Aleco RD-175 - Manual (Page 4)

Step
3
Adjustments
Note: Door not shown for clarity.
3.1 Loosen the two hardware set screws on the bottom of the hardware housing.
3.2 Using the plumb adjustment screws on the sides of the hardware housing, alternately
loosen one side and tighten the other side to bring the doors into plumb. Leading edge
seals should contact each other.
3.3 Secure the doors in place by tightening the hardware set screws.
Hardware Housing Screw
(1/2” x 1/4  20)
Plumb Adjustment
Screw (3/4” x 1/4  20)
Hardware
Set Screws
(1” x 1/4  20)
CONTACT AN ALECO REPRESENTATIVE FOR FURTHER ASSISTANCE
2720 E. Avalon Ave. Muscle Shoals, AL 35661 Phone (256) 2482402 or toll free 18006333120
Fax: 18007509616 email: [email protected] web: www.aleco.com
P/N 994145
0706