American Comfort ACW600C - Manual (Page 14)

12
Never try to repair or dismantle the air condition yourself.
Incompetent repairs result in loss of warranty and can endanger the user and the property.
Problem Cause Solution
The air
conditioner does
not function.
*
No power supply. Make sure the
green light on the plug is lit. Connect to a functioning outlet and switch on.
See below for Plug and Reset button application.
Is the power light flashing?
Is the water full LED lit?
Empty the water container (See pg. 9).
The air
conditioner does
not seem to
perform.
The unit is in direct sunlight. Close curtains/shades
Windows or doors open, many
people or a heat source in the room.
Close doors and windows. Unit is not made to
cool server rooms, sun rooms, or any rooms
generating a constant
The filter is dirty. Clean the filter (See pg. 10).
Air inlet or air outlet blocked.
Power off the unit and unplug from outlet.
Remove blockage.
Room temperature lower than the
selected value. Change temperature selection.
Set at the lowest possible setting: 60°F.
The unit is noisy. Unit stands uneven. Place on an even, solid surface (less vibrations).
The compressor
does not work. The overheat protection may be
activated. Wait 30 minutes until the temperature has
decreased, then turn on the unit again.
The remote
control does not
function.
Distance too great.
Make sure the remote control is correctly aimed
at the control panel.
Remote control signal not detected
by the control panel.
The batteries are drained. Check batteries on remote.
* LCDI Plug
If you plug in the Air Conditioner, and there is no green light on the plug,
press the reset button on the LCDI plug. The green light should be lit,
indicating that the air conditioner is getting power from the electrical outlet.
Make sure unit is plugged directly into a dedicated electrical source/outlet.
Do not use any extension cords. See electrical specifications listed on
page 3 and make sure the electrical source can accommodate the unit’s
energy consumption.
If the plug continues to trip (which is a USA national safety standard feature)
and the green light goes off, the cord may be damaged preventing you from
resetting the unit. For your safety, contact a licensed electrician.
RESET
TEST
Reset Button
Test Button
Green Light
Troubleshooting
Note: When abnormal situations occur, turn off the machine and pull out the plug, then
contact a professional electrician for help.