Audient ASP510 Surround Sound Controller - Manual (Page 12)

Operation Manual
12
Functions & Controls
©audient 5/2001
ASP510 REMOTE
CONTROL
The main Volume control
operates via high precision
Digital Attenuators to
adjust the level of all
speaker outputs. Cut and
Dim controls are also
provided with the Dim level
being user settable.
The monitors may also be
set to a user predetermined
reference level using the
REF switch - the volume
control is then bypassed.
Each of the six speaker
outputs has an individual
twin mode illuminated
switch. These can be set
to operate either as Isolate
or Cut switches by using
the associated mode
switch.
To make system setup
straight forward the
ASP510 has a built in Pink
Noise generator.
9. REF sets all monitor
levels to a user -
definable reference
level independent of the
volume control setting.
To set the Reference
Level hold down the
REF button until it
flashes, release it, set
the required level using
the main Volume
Control and then push
REF again to store the
setting.
7/8 To turn on the PINK
NOISE generator hold
down both the CUT
and DIM buttons
simultaneously until
they flash and then
release them. All
monitors are now cut
but can be unmuted
individually for
alignment. To turn off
the Pink Noise
generator push either
the CUT or DIM button.
SURROUND CONTRO LLER
BUS E NC O/P
SURROUND
STEREO
ENCODER/
DECODER
MONITOR SOURCE
STEREO RECORD SO URCE
MONITOR FORMAT
ISOL ATE
GUIDE MODE
VOLUM E
SURROUND CONTRO LLER
4
5
8 7 9 6
SPEAKER CONTROL
4/5.MODE sets the six
illuminated speaker
switches to act in
either ISOLATE or CUT
mode. An illuminated
legend shows which
mode is active. The
120Hz low pass filter
in the sub-woofer path
is activated by holding
down the illuminated
SUB speaker switch
until the filter legend
illuminates. To bypass
the filter push again
until the legend is
extinguished.
6. The main monitor
VOLUME control.
7. DIM allows all monitor
speakers to be
attenuated by a user-
settable amount. To
set the DIM Level hold
down the DIM button
until it flashes, release
it, set the required level
with the main volume
control and then push
DIM again to store the
setting.
8. CUT mutes all monitor
speakers.