Audient ASP510 Surround Sound Controller - Manual (Page 7)

Operation Manual
Installation
7 ©audient 5/2001
CONTROL INTERFACES
The ASP510 allows various logic control
signals from the host mixing console to
be interfaced to allow continued operation
of console solos etc. These connections
are detailed on the next page and are made
via AC/DC floating opto-isolators that will
successfully detect any positive or negative
going control voltage between 2v and 24v.
Console solo and talkback systems differ
widely and the relevant manufacturer
should be consulted for details of suitable
ways of deriving logic output signals
interfacing to the ASP510.
REMOTE CONTROL
CONNECTION
The ASP510 Surround Processor rack unit
is connected to its remote control via a
standard CAT5 data cable which plugs into
the REMOTE socket on each unit. A 5m
cable is supplied with the unit but any non-
reversed CAT5 FTP (sheilded twisted pair)
cable may be used. The maximum
recommended length of cable is 20m
DEFAULTS
When you first turn on your ASP510 it will load the following default set-up:
MONITOR FORMAT: 5.1
ALTERNATE SPEAKERS: OFF
STEREO RECORD SOURCE: BUS
MONITOR SOURCE: SURROUND RECORD
ENCODER/DECODER: OUT
GUIDE: OFF
REF: OFF
REFERENCE LEVEL: -10dB
VOLUME: FULLY COUNTER-CLOCKWISE
DIM: ON
DIM LEVEL: -20dB
CUT: CUT
MODE: CUT
SPEAKERS: ON
MONITOR TRIMS: 0dB
To restore these defaults hold down the Bypass button until it flashes and then
release it.