Badger Meter Model IOG - Manual (Page 9)

INSTALLATION
Connecting the ER-500 to a Pulse Output Device
The ER-500 monitor has two jumpers that are used to set the type of signal and the minimum amplitude of the signal that
it accepts When used with Badger Meter IOG oval gear meters the Input Signal Level should be set to Low and the Input
Waveform should be set for Pulse as shown in Figure 4
JP1
JP2
JP3
Input
Total P
ulse
Sig
nal
Mag
Pulse
Iso
OC
Low
High
Input Waveform
Selection
(Should be set to Pulse for IOG meter)
Input Signal Level
Selection
(Should be Set to Low for IOG Meter)
Figure 4: Input jumper settings
The ER-500 is configured at the factor to match the IOG meter ordered with it If the ER-500 is a replacement it must be
calibrated for the IOG it is intended to be used with The K factor for the specific IOG meter must be programmed into
the ER-500 The K factor value is found on the calibration certificate that came with the IOG meter For instructions on
programming the K factor see Enter Flow Sensor's K factor (KFactor)
Transmitter Connections
The ILR transmitter typically used with the IOG meter family has two sets of pulse output wires The white and green output
leads connected to the primary reed switch bank are generally the first choice (See Figure 5 )
JP1
JP2
JP3
Input
Total P
ulse
Sig
nal
P1
Freq. In
4-20mA
Iso Total Pluse
TR_B
TR_A
RS485 Gnd
Setpoint 1
Setpoint 2
Gnd
+
–
+
–
+
–
Total Reset
OC Total Pluse
Signal Gnd
TB1
Mag
Pulse
Iso
OC
Low
High
Freq. In
Gnd
Mag
Pulse
+
–
Reed Switch
Bank
ILR
Pulse Transmitter
White
Green
Blue
Black
Auxiliary Reed
Switch Bank
Figure 5: Typical IOG meter input connection
User Manual
Page 9 August 2013