APC MGE 300 - Manual (Page 9)

5 MGE™ Galaxy™ 300 10-40 kVA 3:3, 10-30 kVA 3:1 - 380/400/415 V Installation
2. Connect the batteries to
the battery breaker by
running the cables from
the battery breaker to
each shelve. Note! Make
sure to run the cables in
this order.
Battery enclosure without pre-installed batteries
Warning: APC by Schneider is not responsible for the wiring of external non-APC
batteries.
Warning: Remove all cardboard used to protect the batteries during transport. Make
sure that cables and copper bars are separated.
Note: Before the installation of batteries, you must select and follow the diagram under
“Appendix” on page 16 which applies to your configuration.
Note: The maximum weight of each battery shelf is 155 kg.
Note: A maximum of four battery shelves can be installed.
Front view

+
N
-