AT&T F160 - Manual (Page 5)

Getting Started
6
Getting Started
7
Getting to Know Your Phone
Earpiece
Left Soft Key
Send Key
Multitask
Manager Key
* Key
Microphone
OK Key
LCD Screen
4-Way
Navigation Key
Right Soft Key
Power/End Key
Clear & Back Key
# Key
Speaker Camera
Lens
Charger/
Headset
Port
Camera
Key
Headset
Jack
Volume
Up/Down
Keys
Back Cover
microSD™
Card Slot
SIM Card
Slot
4. When the battery is fully charged,
unplug the charger and disconnect it
from the phone.
Notes:
• Make sure the charger’s connector is
inserted correctly. Do not force the
connector into the port.
• The battery will remain fully charged for
3 to 4 hours.
• Only use the charger provided by the
original provider. Using an unapproved
charger might be dangerous and violate
the authorization and warranty rules of
the phone.
• If the phone is used too often when
the battery is low or not used for a long
time, the screen may not display the
charge indicator until the battery has
been continuously charged for 10 to
40 minutes.
• To get the maximum performance out of
your battery, it is recommended that you
completely charge the battery before
using the phone for the first time. A
new battery’s full performance is only
reached after three complete charge and
discharge cycles have been finished.
• Charging is only possible within a
temperature range of 32°F to 113°F.
Powering Phone On/Off
Note:
• Do not turn your phone on in areas
in which wireless phone use is not
permitted, or when it could cause
interference or danger.
Hold the Power/End Key to turn the phone
on or off.
Tips:
• When prompted, enter your PIN
(Personal Identification Number) code
or handset code and press the OK Key.
• The PIN code is the password provided
by your network service provider. You
cannot use the SIM card without it.
• When the PIN code or handset code
is accepted, the phone automatically
searches for the network. After a few
seconds, your phone displays idle mode.