Innotech Device Communications - Manual (Page 34)

© MASS ELECTRONICS Pty Ltd 2011
DS 99.05 – Ethernet Setup Manual for Device Communications
Page 26
Edition 1.0 dated 04/10/11
4
A warning window will be displayed. Click on 6. Continue to apply and save the new
Ethernet settings on the IG03 or IG04, as illustrated in Figure 4-24 below.
If you are having difficulty accessing the IG03 or IG04 embedded web server at
any point, refer to Chapter 5 – General Troubleshooting for general troubleshooting
IG04 Ethernet Tab – Configure Ethernet settings Figure 4-23:
FusionLIVE – Click continue in Warning window Figure 4-24:
Enter the IP address and the subnet mask in the appropriate fields and click on 5. Apply
to save the new settings.
MUST be configured
as Static
NOTE
It is recommended to configure the IG03 or IG04 with a static IP address to avoid communication
problems. Therefore leave the Address Type option at the default setting of Static.
NOTE
Please note that when the IP address of your device is changed and saved as described here, you may
have to modify your computer network settings to be on the same network range as your device if it is
different. You can then access the embedded web server by entering the new IP address assigned to
your device into the browser address bar.